User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for Wireless Router Mode
- Chapter 5. Configuration for Access Point Mode
- Chapter 6. Configuration for Range Extender Mode
- Chapter 7. Configuration for Client Mode
- Chapter 8. Configuration for Hotspot Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
TL-WR902AC
AC750 Wireless Travel Router
- 224 -
8.10 Advanced Routing
There are two submenus under the Network menu: Static Routing List and System Routing
Table. Click any of them, and you will be able to configure the corresponding function.
8.10.1 Static Routing List
Choose menu “Static Routing”, and you can configure the static route in the next screen. A
static route is a pre-determined path that network information must travel to reach a specific host
or network.
To add static routing entries, follow the steps below.
1. Click Add New…, and you will see the following screen.
2. Enter the following data.
Destination Network - The Destination IP Address is the address of the network or host
that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.