User's Manual
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Internet
- Chapter 3. Configuration for Router Mode
- 3.1 Login
- 3.2 Quick Setup
- 3.3 Basic
- 3.4 Advanced
- 3.4.1 Status
- 3.4.2 Network
- 3.4.3 Wireless
- 3.4.4 Wireless Statistics
- 3.4.5 Guest Network
- 3.4.6 DHCP
- 3.4.7 Forwarding
- 3.4.8 Security
- 3.4.9 Parental Control
- 3.4.10 Access Control
- 3.4.11 Advanced Routing
- 3.4.12 Bandwidth Control
- 3.4.13 IP & MAC Binding
- 3.4.14 ARP List
- 3.4.15 Dynamic DNS
- 3.4.16 No-IP DDNS
- 3.4.17 IPv6 Support
- 3.4.18 System Tools
- 3.4.19 Diagnostic
- 3.4.20 Firmware Upgrade
- Chapter 4. Range Extender Mode
- Chapter 5. Access Point Mode
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
120
TL-WR941HP
450Mbps High Power Wireless N Router
Figure 4-13 Wireless Statistics
Rate - The Throughput unit.
Run Time – The time this function is running.
Transmit – Wireless transmit rate information.
Receive – Wireless receive rate information.
Click the Start button to start wireless throughput monitor.
Click the Stop button to start wireless throughput monitor.
4.3.4 DHCP
There are three submenus under the DHCP menu: DHCP Settings, DHCP Client List and
Address Reservation. Click any of them, and you will be able to configure the corresponding
function.