User's Manual

TL-WR941N/TL-WR941ND Wireless N Router

any of them, you will be able to configure the corresponding function.

4.6.1 Wireless Settings

Choose menu “Wireless

Wireless Setting”, you can configure the basic settings for the

wireless network on this page.

Figure 4-12 Wireless Settings

¾ SSID - Enter a value of up to 32 characters. The same name of SSID (Service Set

Identification) must be assigned to all wireless devices in your network. Considering your

wireless network security, the default SSID is set to be TP-LINK_xxxxxx (xxxxxx indicates

the last unique six numbers of each Router’s MAC address). This value is case-sensitive.

For example, TP-LINK is NOT the same as tp-link.

¾ Channel - This field determines which operating frequency will be used. The default channel

is set to 6. It is not necessary to change the wireless channel unless you notice interference

problems with another nearby access point

¾ Channel width - Select any channel width from the pull-down list. The default setting is

automatic, which can adjust the channel width for your clients automatically.

¾ Enable Wireless Router Radio - The wireless radio of this Router can be enabled or

disabled to allow wireless stations access.

¾ Enable SSID Broadcast - When wireless clients survey the local area for wireless networks

to associate with, they will detect the SSID broadcast by the Router. If you select the Enable

SSID Broadcast checkbox, the Wireless Router will broadcast its name (SSID) on the air.

4.6.2 Wireless Security

Choose menu “Wireless

Wireless Security”, you can configure the security settings of your

wireless network.

There are five wireless security modes supported by the Router: WEP (Wired Equivalent Privacy),

WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi Protected Access 2), WPA2-PSK (Pre-Shared Key),