User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- Set Up the Router as an Access Point
- TP-Link Cloud Service
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Use WPS for Wireless Connection
- 13. 8. Set Wireless MAC Filtering
- 13. 9. Schedule Your Wireless Function
- Manage the Router
- 14. 1. Set Up System Time
- 14. 2. Test the Network Connectivity
- 14. 3. Upgrade the Firmware
- 14. 4. Backup and Restore Configuration Settings
- 14. 5. Set the Router to Reboot Regularly
- 14. 6. Change the Administrator Account
- 14. 7. Local Management
- 14. 8. Remote Management
- 14. 9. System Log
- 14. 10. Monitor the Internet Traffic Statistics
- 14. 11. System Parameters
- FAQ
99
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as
above has been shown to comply with the applicable technical standards, FCC
part 15. There is no unauthorized change is made in the equipment and the
equipment is properly maintained and operated.
Issue Date: 2019.01.15