User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- Set Up the Router as an Access Point
- TP-Link Cloud Service
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Use WPS for Wireless Connection
- 13. 8. Set Wireless MAC Filtering
- 13. 9. Schedule Your Wireless Function
- Manage the Router
- 14. 1. Set Up System Time
- 14. 2. Test the Network Connectivity
- 14. 3. Upgrade the Firmware
- 14. 4. Backup and Restore Configuration Settings
- 14. 5. Set the Router to Reboot Regularly
- 14. 6. Change the Administrator Account
- 14. 7. Local Management
- 14. 8. Remote Management
- 14. 9. System Log
- 14. 10. Monitor the Internet Traffic Statistics
- 14. 11. System Parameters
- FAQ
10
Chapter 2
Connect the Hardware
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, and most USB
network adapters, can be connected to your router through this method.
Note:
• WPS is not supported by iOS devices.
• The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function will be
disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled and is configured with
the appropriate encryption before configuring the WPS.
1 ) Tab the WPS icon on the device’s screen. Here we take an Android phone for
instance.
2 ) Within two minutes, press the Reset/WPS button on your router.
WLAN
On
TP-Link
YSL
David
Hotdog
Ts_5G
Sunny
Test
close to