User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- Set Up the Router as an Access Point
- TP-Link Cloud Service
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Use WPS for Wireless Connection
- 13. 8. Set Wireless MAC Filtering
- 13. 9. Schedule Your Wireless Function
- Manage the Router
- 14. 1. Set Up System Time
- 14. 2. Test the Network Connectivity
- 14. 3. Upgrade the Firmware
- 14. 4. Backup and Restore Configuration Settings
- 14. 5. Set the Router to Reboot Regularly
- 14. 6. Change the Administrator Account
- 14. 7. Local Management
- 14. 8. Remote Management
- 14. 9. System Log
- 14. 10. Monitor the Internet Traffic Statistics
- 14. 11. System Parameters
- FAQ
65
Chapter 13
Customize Your Network Settings
The smart connect function helps devices run faster by assigning them to best wireless
bands based on actual conditions to balance network demands.
1. Go to Advanced > Wireless > Wireless Settings.
2. Enable Smart Connect and click Save.
3. Keep the default or set a new SSID and password, and click Save. This SSID and
password will be applied both for 2.4GHz and 5GHz wireless networks.
• To change the security option:
1. Go to Advanced > Wireless > Wireless Settings.
2. Select the wireless network 2.4GHz or 5GHz.
3. Select an option from the Security drop-down list. We recommend you don’t change
the default settings unless necessary. If you select other options, configure the
related parameters according to the help page.
In addition
• Mode - Select a transmission mode according to your wireless client devices. It is
recommended to just leave it as default.
• Channel Width - Select a channel width (bandwidth) for the wireless network.
• Channel - Select an operating channel for the wireless network. It is recommended
to leave the channel to Auto, if you are not experiencing the intermittent wireless
connection issue.
• Transmit Power - Select either High, Middle or Low to specify the data transmit power.
The default and recommended setting is High.