User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- Set Up the Router as an Access Point
- TP-Link Cloud Service
- Guest Network
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Use WPS for Wireless Connection
- 13. 8. Set Wireless MAC Filtering
- 13. 9. Schedule Your Wireless Function
- Manage the Router
- 14. 1. Set Up System Time
- 14. 2. Test the Network Connectivity
- 14. 3. Upgrade the Firmware
- 14. 4. Backup and Restore Configuration Settings
- 14. 5. Set the Router to Reboot Regularly
- 14. 6. Change the Administrator Account
- 14. 7. Local Management
- 14. 8. Remote Management
- 14. 9. System Log
- 14. 10. Monitor the Internet Traffic Statistics
- 14. 11. System Parameters
- FAQ
84
Chapter 14
Manage the Router
1 ) Go to Network > DHCP Server.
2 ) Deselect Enable DHCP Server and click Save.
Now you can go to Advanced > Status > Wireless to check the WDS status. When the
WDS status is Run, it means WDS bridging is successfully built.
14. 11. 3. LEDs Control
The router‘s LEDs indicate router’s activities and status. You can turn on or turn off the
LEDs either from the web management page or by pressing the LED button.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > System Tools > System Parameters. Focus on LED section.
3. Tick the Night Mode checkbox.
4. Specify a time period in the LED Off Time as needed, and the LEDs will be off during
this period.
5. Click Save.
14. 11. 4. DoS Protection Settings
DoS Protection can protect your home network against DoS attacks from flooding your
network with server requests.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > Security > Settings to enable Dos Protection.
3. Go to Advanced > System Tools > System Parameters.
4. Enter a value between 5 and 7200 to trigger the protection immediately when the
number of packets exceeds the preset threshold value.