User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- TP-Link Cloud Service
- Guest Network
- USB Settings
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Schedule Your Wireless Function
- 13. 8. Use WPS for Wireless Connection
- 13. 9. Advanced Wireless Settings
- Manage the Router
- 14. 1. Upgrade the Firmware
- 14. 2. Backup and Restore Configuration Settings
- 14. 3. Change the Login Password
- 14. 4. Password Recovery
- 14. 5. Local Management
- 14. 6. Remote Management
- 14. 7. System Log
- 14. 8. Test the Network Connectivity
- 14. 9. Set Up System Time
- 14. 10. Set the Router to Reboot Regularly
- 14. 11. Control the LED
- FAQ
33
Chapter 7
USB Settings
• Share photos and other large files with your friends without logging in to (and paying
for) a photo-sharing site or email system.
• Get a safe backup for the materials for a presentation.
• Remove the files on your camera’s memory card from time to time during the journey.
Note:
If your ISP assigns a private WAN IP address (such as 192.168.x.x or 10.x.x.x), you cannot use this feature because
private addresses are not routed on the internet.
Follow the steps below to configure remote access settings.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > USB > USB Storage Device.
3. Tick the Internet FTP checkbox, and then click Save.
4. Refer to the following table to access your USB disk remotely.