User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Log In to Your Router
- Set Up Internet Connection
- TP-Link Cloud Service
- Guest Network
- USB Settings
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Customize Your Network Settings
- 13. 1. Change the LAN Settings
- 13. 2. Configure to Support IPTV Service
- 13. 3. Specify DHCP Server Settings
- 13. 4. Set Up a Dynamic DNS Service Account
- 13. 5. Create Static Routes
- 13. 6. Specify Wireless Settings
- 13. 7. Schedule Your Wireless Function
- 13. 8. Use WPS for Wireless Connection
- 13. 9. Advanced Wireless Settings
- Manage the Router
- 14. 1. Upgrade the Firmware
- 14. 2. Backup and Restore Configuration Settings
- 14. 3. Change the Login Password
- 14. 4. Password Recovery
- 14. 5. Local Management
- 14. 6. Remote Management
- 14. 7. System Log
- 14. 8. Test the Network Connectivity
- 14. 9. Set Up System Time
- 14. 10. Set the Router to Reboot Regularly
- 14. 11. Control the LED
- FAQ
74
Chapter 13
Customize Your Network Settings
Network Destination: The destination IP address that you want to assign to a static
route. This IP address cannot be on the same subnet with the WAN IP or LAN IP of
Router A. In the example, the IP address of the company network is the destination
IP address, so here enter 172.30.30.1.
Subnet Mask: Determines the destination network with the destination IP address.
If the destination is a single IP address, enter 255.255.255.255; otherwise, enter
the subnet mask of the corresponding network IP. In the example, the destination
network is a single IP, so here enter 255.255.255.255.
Default Gateway: The IP address of the gateway device to which the data packets
will be sent. This IP address must be on the same subnet with the router’s IP which
sends out data. In the example, the data packets will be sent to the LAN port of
Router B and then to the Server, so the default gateway should be 192.168.0.2.
Interface: Determined by the port (WAN/LAN) that sends out data packets. In the
example, the data are sent to the gateway through the LAN port of Router A, so LAN/
WLAN should be selected.
Description: Enter a description for this static routing entry.
5. Click SAVE .
6. Check the Routing Table below. If you can find the entry you’ve set, the static routing
is set successfully.
Done!
Open a web browser on your PC. Enter the company server’s IP address to visit the
company network.
13. 6. Specify Wireless Settings
The router’s wireless network name (SSID) and password, and security option are preset
in the factory. The preset SSID and password can be found on the label of the router.
You can customize the wireless settings according to your needs.
Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for the
router.