User Guide
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect Your Router
- Log In
- Configure the Router
- 4. 1. Status
- 4. 2. Quick Setup
- 4. 3. Operation Mode
- 4. 4. Network
- 4. 5. Dual Band Selection
- 4. 6. Wireless(2.4GHz or 5GHz)
- 4. 7. Guest Network
- 4. 8. DHCP
- 4. 9. Forwarding
- 4. 10. Security
- 4. 11. Parental Controls
- 4. 12. Access Control
- 4. 13. Advanced Routing
- 4. 14. Bandwidth Control
- 4. 15. IP & MAC Binding
- 4. 16. Dynamic DNS
- 4. 17. IPv6
- 4. 18. System Tools
- 4. 19. Log Out
- Configure the Router in Access Point Mode
- Configure the Router in Range Extender Mode
- FAQ
5
Chapter 1
Get to Know About Your Router
Item Description
Reset Button
Press and hold this button until all the LEDs turn off to reset the router to its factory
default settings.
Wi-Fi/WPS Button
Press this button, and immediately press the WPS button on your device. The WPS
LED of the router should change from flashing to solid on, indicating successful WPS
connection.
Press and hold this button for about 5 seconds to turn on or off the wireless function
of your router.
WAN Port For connecting to a DSL/Cable modem, or an Ethernet port.
Ethernet Ports (1/2/3/4) For connecting your PCs or other wired network devices to the router.
Antennas
Used for wireless operation and data transmitting. Upright them for the best Wi-Fi
performance.