Quick Start Guide

Connecting the Hardware

If your internet connection is through an Ethernet cable directly from the

wall instead of through a DSL / Cable / Satellite modem, connect the

Ethernet cable to the router’s Internet port, and follow Step 4 and 5 to

complete the hardware connection.

Quick Installation Guide

AC900 Wireless Dual Band Router

C25

Power

Note: If the 2.4G LED and 5G LED are

not on, please press and hold the

WPS/Wi-Fi On/O button on the rear panel

until they are on.

2.4G

Internet

Turn on the modem, and

then wait about 2 minutes

for it to restart.

Turn o the modem,

and remove the backup

battery if it has one.

Connect the Power adapter

to the router and turn on

the router.

Connect the modem to

the router’s Internet port

with an Ethernet cable.

Verify that the following LEDs are

on and solid to confirm the

hardware is connected correctly.

Modem

Power adapter

Internet

Router

PAGE 1
Quick Installation Guide AC900 Wireless Dual Band Router C25 Power adapter Connecting the Hardware If your internet connection is through an Ethernet cable directly from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable to the router’s Internet port, and follow Step 4 and 5 to complete the hardware connection. Internet 4 Router 1 Turn off the modem, and remove the backup battery if it has one.
PAGE 2
Configuring the Router 1. Connecting your computer to the router (Wired or Wireless) B Follow the step-by-step instructions to set up the internet connection and register the TP-LINK ID. Wired Turn off the Wi-Fi on your computer and connect the devices as shown below.