User manual

Quick Installation Guide

AC1200 Wireless Dual Band Router

If your Internet connection is through an Ethernet cable from the wall

instead of through a DSL / Cable / Satellite modem, connect the Ethernet

cable directly to the router’s Internet port, then follow steps 4 and 5 to

complete the hardware connection.

7106505693 REV2.0.0

Verify that the hardware

connection is correct by

checking these LEDs.

2.4G

On (Green)

Internet

Power

Note: If the 2.4G LED and 5G LED

are oﬀ, please press the Wi-Fi button

on the rear panel for 2 seconds, then

check the LEDs again in a few seconds.

Connecting the Hardware

Modem

Power adapter

Router

Turn on the router.

Internet

Connect the modem to the

Internet port on your router

with an Ethernet cable.

Turn oﬀ the modem,

and remove the backup

battery if it has one.

Turn on the modem, and

then wait about 2 minutes

for it to restart.

PAGE 1
Quick Installation Guide AC1200 Wireless Dual Band Router Power adapter 7106505693 REV2.0.0 Connecting the Hardware If your Internet connection is through an Ethernet cable from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable directly to the router’s Internet port, then follow steps 4 and 5 to complete the hardware connection. 4 Router Internet Power adapter Turn on the router. 1 Turn off the modem, and remove the backup battery if it has one.
PAGE 2
Configure the Router D Select your WAN Connection Type, or click Auto Detect if you are unsure of what your connection type is. Click Next and follow the instructions. 1. Connect your computer to the router (Wired or Wireless) WAN Connection Type Test Your Connection Wireless Settings Wired Turn off the Wi-Fi on your computer and connect the devices as shown below. Region and Time zone USB Features Use the USB port for media sharing, storage sharing and printer sharing across your local network.