Specification Sheet

Power

Note: If the 2.4G LED and 5G LED are

o, please press and hold the Wi-Fi/WPS

button on the back panel for about 5

seconds to turn them on.

Connect the Hardware

2.4G

Internet

Modem

Power adapter

Router

Internet

Turn on the modem, and

then wait about 2 minutes

for it to restart.

If your internet connection is through an Ethernet cable directly from the

wall instead of through a DSL / Cable / Satellite modem, connect the

Ethernet cable to the router’s Internet port, and follow Step 4 and 5 to

complete the hardware connection.

Turn o the modem,

and remove the backup

battery if it has one.

Connect the Power

adapter to the router and

turn on the router.

Connect the modem to the

router’s Internet port with

an Ethernet cable.

Verify that the following LEDs are on

and solid to confirm the hardware is

connected correctly.

Quick Installation Guide

AC900 Wireless Dual Band Gigabit Router

C900

PAGE 1
Quick Installation Guide AC900 Wireless Dual Band Gigabit Router C900 Power adapter Connect the Hardware If your internet connection is through an Ethernet cable directly from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable to the router’s Internet port, and follow Step 4 and 5 to complete the hardware connection. 4 Connect the Power adapter to the router and turn on the router. Router Internet 1 Turn off the modem, and remove the backup battery if it has one.
PAGE 2
Configure the Router 1. Connecting your computer to the router (Wired or Wireless) Wired Turn off the Wi-Fi on your computer and connect the devices as shown below. B Follow the step-by-step instructions to set up the internet connection and register a TP-Link ID. Internet Connection Type Time zone Ethernet cable Wireless Settings TP-Link Cloud Service TP-Link Cloud service provides a better way to manage your cloud devices.