User Manual
Table Of Contents
- About This Guide
- Get to Know Your Modem Router
- Connect the Hardware
- Log In to Your Modem Router
- Set Up Internet Connections
- TP-Link Cloud Service
- OneMeshTM with Seamless Roaming
- IPTV
- Guest Network
- USB Settings
- Parental Controls
- QoS
- Network Security
- NAT Forwarding
- VPN Server
- Specify Your Network Settings
- Administrate Your Network
- 16. 1. Set System Time
- 16. 2. Control LEDs
- 16. 3. Update the Firmware
- 16. 4. Back up and Restore Configuration Settings
- 16. 5. Reboot the Modem Router
- 16. 6. Change the Administrator Account
- 16. 7. Local Management
- 16. 8. Remote Management
- 16. 9. System Log
- 16. 10. Monitor the Internet Traffic Statistics
- 16. 11. CWMP Settings
- 16. 12. SNMP Settings
- Appendix: Troubleshooting
97
Chapter 15
Specify Your Network Settings
15. 6. 2. Specify the 6rd Tunnel with Parameters Provided by Your ISP
I want to:
Specify the 6rd tunnel with the parameters provided by my 6rd tunnel service provider.
How can I do that?
1. Visit
http://tplinkmodem.net, and log in with your TP-Link ID or the password you
set for the router.
2. Go to
Advanced > Network > IPv6 Tunnel.
3. Tick the check box, select 6rd as the tunneling mechanism and select a WAN
connection from the drop-down list.
4. According to the parameters provided by your ISP, choose
Auto or Manual. More
parameters are needed if you choose
Manual.
5. Click
Save.
Note:
If there is no available WAN connection to choose, make sure you have connected to the internet and the connection
type is not Bridge.
Done!
Now you can visit the IPv6 websites with the 6rd tunnel.
Tips:
The way to set up DS-Lite tunnel is similar to that of 6rd tunnel. If you are provided with an IPv6-only WAN connection
and have signed up for DS-Lite tunnel service, specify the DS-Lite tunnel by referring to the steps above.