Users Manual Part 1

Chapter 4

Set Up Internet Connection

3. After rebooting, connect the router to your existing wired router via an Ethernet cable.

4. Connect to the Wi-Fi of the router and log in again to the web management page

http://tplinkwifi.net, and go to Advanced > Quick Setup.

5. Configure your wireless settings and click Next.

6. Confirm the information and click SAVE. Now, you can enjoy Wi-Fi.

Tips: Functions, such as Parental Controls, QoS and NAT Forwarding, are not supported in the Access Point mode.

4. 5. Set Up an IPv6 Internet Connection

Your ISP provides information about one of the following IPv6 internet connection types:

PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).

1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for

the router.

2. Go to Advanced > IPv6.

3. Enable IPv6 and select the internet connection type provided by your ISP.

Tips: If you do not know what your internet connection type is, contact your ISP or judge according to the already

known information provided by your ISP.

4. Fill in information as required by different connection types. Red blanks must be filled

in.