Installation Instructions

2. Connection and Installation

At the selected site,

approximately align the

CPE to the direction that

you have oriented.

You should prepare an adequate

Ethernet cable to connect the CPE

and the passive PoE adapter.

Shielded CAT5e (or above) cable

with ground wire is recommended

(refer to the next section).

Please connect and install the device as shown in the  gure below.

Connect to a computer,

router or switch.

(Depending on your

intended usage and/or

network topology.)

Ethernet cable length up to 60m

Slide to replace the cover

of the CPE when all

connections are  nished.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

FCC ID:TE7CPE510

MADE IN CHINA

IC:8853A-CPE510

Default Settings:

IP: 192.168.0.254 Username: admin Password: admin

Model: CPE510

Power: 24V 1A

5GHz 300Mbps 13dBi Outdoor CPE

5734

POE

LAN0

LAN