Authentication Omada EAP
For Class A EAP with adapter: FCC Compliance Information Statement Product Name: Omada EAP Model Number: EAP110 / EAP110-Outdoor Component Name Model I.T.E. Power Supply TL-POE2406 Responsible party: TP‑Link USA Corporation, d/b/a TP‑Link North America, Inc. Address: 145 South State College Blvd. Suite 400, Brea, CA 92821 Website: https://www.tp‑link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6803 E‑mail: sales.usa@tp‑link.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. “To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated. Issue Date:2020-5-12 CE Mark Warning This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. For EAP110-Outdoor: This radio transmitter (IC: 8853A-EAP110OD / Model: EAP110-Outdoor) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated.
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通行；經發現有干擾現象時，應立即停 用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信規定作業之無線電信。低功率射頻電機 需忍受合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。 安全諮詢及注意事項 ■■ 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 ■■ 清潔本產品之前請先拔掉電源線 . 請勿使用液體、噴霧清潔劑或濕布進行清潔。 ■■ 注意防潮，請勿將水或其他液體潑灑到本產品上。 ■■ 插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。 ■■ 請勿將本產品置放於靠近熱源的地方 .
■■ Do not use the device where wireless devices are not allowed ■■ Adapter shall be installed near the equipment and shall be easily accessible. Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don’t hesitate to contact us. Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device.
For Class B EAP with adapter: FCC Compliance Information Statement Product Name: Omada EAP Model Number: EAP115 / EAP225 / EAP245 / EAP265 HD / EAP620 HD / EAP660 HD / EAP225Outdoor Component Name Model T090060-2B1 (For EAP115) TL-POE2412G (For EAP225 / EAP225-Outdoor) I.T.E. Power Supply T120150-2B1 (For EAP245) T480050-2-POE (For EAP265 HD) T120100-2B1 (For EAP620 HD) T120200-2B1 (For EAP660 HD) Responsible party: TP‑Link USA Corporation, d/b/a TP‑Link North America, Inc.
connected. •• Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
•• Reorient or relocate the receiving antenna. •• Increase the separation between the equipment and receiver. •• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •• Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference.
EU declaration of conformity TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863. The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce. RF Exposure Information This device meets the EU requirements (2014/53/EU Article 3.1a) on the limitation of exposure of the general public to electromagnetic fields by way of health protection.
Le présent émetteur radio (IC: 8853A-EAP225OD / Model: EAP225-Outdoor) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste ci-dessous et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Antenna Two 2.
Korea Warning Statements 당해 무선설비는 운용중 전파혼신 가능성이 있음 . NCC Notice & BSMI Notice 注意！ 依據 低功率電波輻射性電機管理辦法 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加 大功率或變更原設計之特性或功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通行；經發現有干擾現象時，應立即停 用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信規定作業之無線電信。低功率射頻電機 需忍受合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。 針對EAP225 / EAP245 / EAP265 HD / EAP620 HD / EAP660 HD / EAP225-Outdoor： 4.7.9.1應避免影響附近雷達系統之操作。 4.7.9.2高增益指向性天線只得應用於固定式點對點系統。 安全諮詢及注意事項 ■■ 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 ■■ 清潔本產品之前請先拔掉電源線 .
Safety Information ■■ Keep the device away from water, fire, humidity or hot environments. ■■ Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us. ■■ Do not use damaged charger or USB cable to charge the device. ■■ Do not use any other chargers than those recommended. ■■ Do not use the device where wireless devices are not allowed ■■ Adapter shall be installed near the equipment and shall be easily accessible.
RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment.
For Class B EAP with no adapter: FCC Compliance Information Statement Product Name: Omada EAP Model Number: EAP115-Wall / EAP225-Wall / EAP230-Wall / EAP235-Wall Responsible party: TP‑Link USA Corporation, d/b/a TP‑Link North America, Inc. Address: 145 South State College Blvd. Suite 400, Brea, CA 92821 Website: https://www.tp‑link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6803 E‑mail: sales.usa@tp‑link.
Note: The manufacturer is not responsible for any radio or T V interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
RF Exposure Information This device meets the EU requirements (2014/53/EU Article 3.1a) on the limitation of exposure of the general public to electromagnetic fields by way of health protection. The device complies with RF specifications when the device used at 20 cm from your body. National Restrictions For EAP225-Wall / EAP230-Wall / EAP235-Wall: Attention: In EU member states and EFTA countries, the operation in the frequency range 5150MHz - 5350MHz is only permitted indoors.
Avertissement For EAP225-Wall / EAP230-Wall / EAP235-Wall: 1) Le dispositif fonctionnant dans la bande 5150-5250 MHz est réservé uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; 2) Le gain maximal d'antenne permis pour les dispositifs avec antenne(s) amovible(s) utilisant les bandes 5250-5350 MHz et 5470-5725 MHz doit se conformer à la limitation P.I.R.E.
安全諮詢及注意事項 ■■ 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 ■■ 清潔本產品之前請先拔掉電源線 . 請勿使用液體、噴霧清潔劑或濕布進行清潔。 ■■ 注意防潮，請勿將水或其他液體潑灑到本產品上。 ■■ 插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。 ■■ 請勿將本產品置放於靠近熱源的地方 . 除非有正常的通風，否則不可放在密閉位置中。 ■■ 不要私自拆開機殼或自行維修，如產品有故障請與原廠或代理商聯繫。 限用物質含有情況標示聲明書 產品元件名稱 PCB 外殼 鉛 Pb 鎘 Cd ○ ○ ○ ○ 限用物質及其化學符號 汞 Hg 六價鉻 CrVI 多溴聯苯 PBB 多溴二苯醚 PBDE ○ ○ ○ ○ ○ ○ ○ ○ 備考1. "超出0.1 wt %" 及 "超出0.01 wt %" 系指限用物質之百分比含量超出百分比含量基準值. 備考2."○"系指該項限用物質之百分比含量未超出百分比含量基準值. 備考3."—" 系指該項限用物質為排除項目.
Symbol Explanation Class II equipment AC voltage Indoor use only. Polarity of output terminals Energy efficiency marking (Level VI) RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
