Full Product Manual

ManualsBrandsTP-LINK ManualsElectricalSmart Wi-Fi Light Switch (2-Pack)

Smart Wi-Fi Light Switch Installation

Important Safety Information

Before installing, servicing, or removing the Smart Switch, read and follow all safety precautions

including the following:

• WARNING: RISK OF ELECTRIC SHOCK OR FIRE. Turn OFF power supply at the circuit breaker or

fuse. Use a non-contact voltage tester to ensure the power is off.

• The Smart Switch must be installed and used in accordance with the National Electric Code (NEC)

or your local electrical code. If you are unfamiliar with these codes and requirements, or are

uncomfortable performing the installation, consult a qualified electrician.

• The Smart Switch is an indoor single-pole switch that requires a neutral connection.

• Do not install the Smart Switch with wet hands or when standing on wet or damp surfaces.

1 Download TP-LINK Kasa from App Store or Google Play.

2 Connect mobile device to your 2.4GHz Wi-Fi network.

Apple and App Store are trademarks of

Apple Inc., registered in the U.S. and

other countries.

Android and the Google Play logo are

trademarks of Google Inc.

3 Launch Kasa and follow the wiring steps provided, then connect the

Smart Switch to your home network.

Quick Start Guide

HS200

7106506280 REV 1.0.0

Sketch 9:41 AM 100%

Before we start

Have you already wired up your

Smart Switch?

NOT YET

Yes, I have

Create Account

Skip

Forgot password?

Password

Welcome

home

Sketch 9:41 AM 100%

Start the con guration

Locate the reset button below the

switch on the left.

Press and hold for 5 seconds until the

Wi-Fi light blinks amber and green.

RESET

scan QR

code

Note: The Smart Switch

only supports 2.4GHz

networks.

Summary of content (2 pages)

PAGE 1
Quick Start Guide HS200 Important Safety Information Before installing, servicing, or removing the Smart Switch, read and follow all safety precautions including the following: • WARNING: RISK OF ELECTRIC SHOCK OR FIRE. Turn OFF power supply at the circuit breaker or fuse. Use a non-contact voltage tester to ensure the power is off. • The Smart Switch must be installed and used in accordance with the National Electric Code (NEC) or your local electrical code.
PAGE 2
Smart Wi-Fi Light Switch Blinking Amber and Green: App-Config mode initiated. Green: Successfully connected to the Wi-Fi network. Blinking Amber: Resetting or during firmware update. Red: No Wi-Fi connection. White: Lit up when the light is switched OFF to show the Smart Switch location in the dark. RESTART RESET Press to reboot the Smart Switch. Press and hold (about 5 seconds) until the Wi-Fi status LED blinks amber and green alternately to initiate App-Config mode.