Quick Start Guide

Kasa Smart Wi-Fi Light Switch, Single Pole

Quick Start Guide

*Images may dier from your actual product.

Wire Your Switch

Disconnect wires from the old switch.

Turn o the circuit breaker. Then remove

the old wallplate of the wall switch and

label the wires.

Connect the wires to the smart switch as

shown below.

Note: No need to distinguish between Line and Load wires.

Ground: Usually green or copper.

Neutral: Usually white, not connected to the dumb switch.

Line/Load: Usually black, and connected to the dumb

switch.

If you are unsure, consult a qualied electrician.

Line up the switch with the mounting

holes. Secure it with screws.

Attach the wallplate. Then the wiring is

nished.

Flip the page over to complete setup.

Power

Source

To Light

PAGE 1
Wire Your Switch 1 Turn off the circuit breaker. Then remove the old wallplate of the wall switch and label the wires. 3 Connect the wires to the smart switch as shown below. Line up the switch with the mounting 4 holes. Secure it with screws. Attach the wallplate. Then the wiring is 5 finished. To Light Quick Start Guide Kasa Smart Wi-Fi Light Switch, Single Pole Ground: Usually green or copper. Neutral: Usually white, not connected to the dumb switch.
PAGE 2
Set Up Your Switch STEP 1 Appearance Button Explanations DOWNLOAD APP Reset Get the Kasa Smart app from the App Store or Google Play. Restart ? Need some help? Visit www.tp-link.com/support for technical support, user guides, FAQs, warranty & more 7106509393 REV1.1.0 ©2022 TP-Link OR STEP 2 SET UP Tap the button in the app and select Smart Switches. Then follow the step-by-step app instructions to set up your smart switch.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.