User manual

TD-8816 ADSL2+ Modem Router User Guide
5
2.2 The Back Panel
Figure 2-2
¾ ON/OFF: The switch for the power.
¾ POWER: The Power plug is where you will connect the power adapter.
¾ RESET: There are two ways to reset the modem router's factory defaults.
Method one: With the modem router powered on, use a pin to press and hold the Reset
button (about 5 seconds) until all LED is lit. And then release the button and wait the modem
router to reboot to its factory default settings.
Method two：Restore the default setting from “Maintenance-SysRestart” of the modem
router's Web-based Utility.
¾ LAN: Through the port, you can connect the modem router to your PC or the other Ethernet
network devices.
¾ ADSL: Through the port, you can connect the modem router with the telephone.
2.3 Installation Environment
¾ The Product should not be located where it will be exposed to moisture or excessive heat.
¾ Place the modem router in a location where it can be connected to the various devices as
well as to a power source.
¾ Make sure the cables and power cord are placed safely out of the way so they do not create a
tripping hazard.
¾ The modem router can be placed on a shelf or desktop.
Generally, TD-8816 is placed on a horizontal surface. The device also can be mounted on the wall
as shown in Figure 2-4 Wall-mount Install.