User manual

TD-8816 ADSL2+ Modem Router User Guide

or given by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and

Gateway IP address.

¾ Dual Stack Line: Enable the Dual Stack Lite( D-S Lite ) function if you need. It is disabled by

default.

4. Bridge Mode

If you select this type of connection, the modem router can be configured to act as a bridging

device between your LAN and your ISP. Bridges are devices that enable two or more networks to

communicate as if they are two segments of the same physical LAN.

¾ Dual Stack Lite: Enable the Dual Stack Lite ( D-S Lite ) function if you need. It is disabled by

default.

Figure 4-10

)

Note:

After you finish the Internet configuration, please click SAVE to make the settings take effect.

4.3.1.2. IPv6

There are two IP versions: IPv4 and IPv6. If you select IPv6 as IP version, please follow the

configuration below to configure the parameters for WAN ports.

¾ Encapsulation: There are four connection types: Dynamic IP Address, Static IP Address,

PPPoA/PPPoE and Bridge Mode. Please choose the designed type that you want to use.

After that, you should follow the configuration below to proceed.

1. Dynamic IP Address

Select this option if your ISP provides you an IP address automatically. This option is typically

used for Cable services. Please enter the Dynamic IP information accordingly.