User manual

TD-8816 ADSL2+ Modem Router User Guide

Figure 4-15

¾ Router Local IP: These are the IP settings of the LAN interface for the device. These

settings may be referred to as Private settings. You may change the LAN IP address if

needed. The LAN IP address is private to your internal network and cannot be seen on the

Internet.

• IP Address: Enter the modem router’s local IP Address, then you can access to the

Web-based Utility via the IP Address, the default value is 192.168.1.1.

• IP Subnet Mask: Enter the modem router’s Subnet Mask, the default value is

255.255.255.0.

• Dynamic Route: Select this option to specify the RIP (Routing Information protocol)

version for LAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are

both sent in RIP2 format, the difference is that RIP2-M using Multicast, while RIP2-B

using Broadcast format.

• Direction: Select this option to specify the RIP direction. None means disabling the RIP