Manualshelf

Quick Installation Guide

ManualsBrandsTP-LINK ManualsWLANWLAN repeater 1.75 Gbit/s 2.4 GHz, 5 GHz
12
Quick Installation Guide
7106507935 REV3.0.0
Plug the extender into a power outlet next to your router. Wait until its
POWER LED turns solid on.
Power On
1
On
Relocate and Enjoy
3
Enjoy the internet!
Extended NetworkHost Network
Signal LED
Blue: Suitable location
Red: Too far away
Network Names:
Customized/Same as host network
Passwords:
Same as host network
1. Plug in the extender about halfway between your router and the Wi-Fi dead
zone. The location you choose must be within the range of your host network.
2. Wait until the LED turns solid blue. If it doesn't, relocate the extender
closer to the router to achieve better signal quality.
Method 1: Via a Web Browser
1. Connect your computer or smartphone to the
extender’s network.
2. Launch a web browser, and enter
http://tplinkrepeater.net or http://192.168.0.254
in the address bar. Create a password to log in.
Note: If the login window does not appear, refer to FAQ > Q1.
http://tplinkrepeater.net
Start
Conrm Password
Create Password
Low Middle High
TP-Link_Extender_2.4GHz
TP-Link_Extender_5GHz
Connect and Extend
2
Method 3: Via the WPS Button
1. Press the WPS button on your router.
The extended networks share the same network
names and passwords as your router.
Note:
1. If the extender connects to a dual band router but only the
2.4GHz or 5GHz LED is on, repeat steps 1 and 2 above to
connect to the other band.
2. If the WPS method fails, or if you want to customize the
extended network names, use Method 1 or 2.
The WPS button might
look like one of these:
Blinking On
The LED should
change from blinking to
solid on, indicating
successful connection.
2. Within 2 minutes, press the button on the
extender for 1 second.
Method 2: Via the Tether App
1. Download the Tether app.
2. Connect your smartphone to the extender’s
network.
3. Launch the Tether app, and select your extender.
Create a password to log in.
Scan for Tether Tether
or
TP-Link_Extender_2.4GHz
TP-Link_Extender_5GHz
3. Follow the instructions to complete the setup.
Note:
1. The LED should turn solid on. If not, refer to FAQ > Q3.
2. You can customize the network names during the setup.
4. Follow the instructions to complete the setup.
Note:
1. The LED should turn solid on. If not, refer to FAQ > Q3.
2. You can customize the network names during the setup.

Summary of content (2 pages)