Quick Start Guide

Meet Your Motion Sensor

Motion Sensor detects movement in a certain area and triggers dierent actions

in response to the movement, making your home even smarter.

Quick Start Guide

7106509249 REV1.0.0

Before You Start

A Tapo Hub is required. Make sure

your Tapo Hub is successfully added

via the Tapo app.

1. Power Up Your Sensor

a. Pull up the clip. Then twist the cover

anticlockwise with your other hand to

remove the cover.

b. Remove the battery insulation

tab to power up your sensor.

Open the Tapo app, tap the button

in the app, and select your sensor.

Follow the app instructions to

complete the setup.

2. Set Up Your Sensor

Reset

Button

Battery

Compartment

Sensor

Detector

LED

Mounting

Stand

Cover

Images may dier from acutal produtcs.

Motion

Sensor

PAGE 1
Meet Your Motion Sensor Quick Start Guide Motion Sensor 7106509249 REV1.0.0 Images may differ from acutal produtcs. Motion Sensor detects movement in a certain area and triggers different actions in response to the movement, making your home even smarter. Mounting Stand Sensor Detector LED Cover Reset Button Battery Compartment Before You Start A Tapo Hub is required. Make sure your Tapo Hub is successfully added via the Tapo app. OR 1. Power Up Your Sensor a. Pull up the clip.
PAGE 2
Wave your hand in front of the sensor to test it. The Tapo app should show that the sensor has been triggered. 4. Place Your Sensor Place the sensor on a flat surface, or use the magnet base or the included 3M adhesive to stick your sensor nearly anywhere. OR The recommended installation height is 1.5m to 2m. Outside these parameters will reduce the optimal performance of the sensor.
PAGE 3
CAUTION! Avoid replacement of a battery with an incorrect type that can defeat a safeguard. Avoid disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.