Quick Start Guide

Safety Information
Keep the device away from water, re, humidity or hot
environments.
Do not attempt to disassemble, repair, or modify the device. If
you need service, please contact us.
Do not use the device where wireless devices are not allowed.
Please read and follow the above safety information when
operating the device. We cannot guarantee that no accidents
or damage will occur due to improper use of the device.
Please use this product with care and operate at your own
risk.
Do not ingest battery, Chemical Burn Hazard
This product contains a coin / button cell battery. If the coin /
button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop
using the product and keep it away from children.
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
Use a pin to press and hold the Reset
button for 3 seconds until the front
LED starts blinking.
How to enter pairing mode
3. Test Your Sensor
Wave your hand in front of the sensor
to test it. The Tapo app should show
that the sensor has been triggered.
4. Place Your Sensor
Place the sensor on a at surface, or use the
magnet base or the included 3M adhesive to
stick your sensor nearly anywhere.
The recommended installation height is 1.5m to 2m. Outside these parameters will reduce
the optimal performance of the sensor.
Need some help?
?
Visit www.tapo.com/support/
for technical support, user guides,
FAQs, warranty & more
©2021 TP-Link
OR
5m3m1m
2m
5m3m1m
120°
Detection Area - Side View Detection Area - Top View
CAUTION!
Avoid replacement of a battery with an incorrect
type that can defeat a safeguard.
Avoid disposal of a battery into re or a hot oven,
or mechanically crushing or cutting of a battery,
that can result in an explosion.
Do not leave a battery in an extremely high
temperature surrounding environment that can
result in an explosion or the leakage of ammable
liquid or gas; Do not leave a battery subjected to
extremely low air pressure that may result in an
explosion or the leakage of ammable liquid or gas.
Operating Frequency / max output power:
868MHz~868.6MHz / 25mW (e.r.p)
TP-Link hereby declares that the device is in
compliance with the essential requirements and
other relevant provisions of directives 2014/53/EU,
2009/125/EC, 2011/65/EU and (EU) 2015/863.
The original EU declaration of conformity may be
found at https://www.tapo.com/en/support/ce/
TP-Link hereby declares that the device is in compliance
with the essential requirements and other relevant
provisions of the Radio Equipment Regulations 2017.
The original UK declaration of conformity may be found
at https://www.tapo.com/support/ukca/