CLI Reference Guide

184
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the SNMP notification for port 1/0/1:
T1500-28PCT(config)# interface fastEthernet 1/0/1
T1500-28PCT(config-if)# lldp snmp-trap
lldp tlv-select
Description
The lldp tlv -sele ct command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-se le ct [ port-description | system-capability | system-description |
system-name | management-address | port-vlan | protocol-vlan | vlan-name |
link-aggregation | mac-phy-cfg | max-frame-size | power | all ]
no lldp tlv-select [ port-description | system-capability | system-description |
system-name | management-address | port-vlan | protocol-vlan | vlan-name |
link-aggregation | mac-phy-cfg | max-frame-size | power | all ]
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from port 1/0/1:
T1500-28PCT(config)# interface fastEthernet 1/0/1
T1500-28PCT(config-if)# no lldp tlv-select management-address port-vlan