CLI Reference Guide

10
gigabitEthernet, Interface link-aggregation and some other modes, which is shown as the following
diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path Prompt
Logout or Access the
next mode
User E XEC
Mode
Primary mode once it is
connected with the switch.
T1500-28PCT>
Use the exit
command to
disconnect the switch.
Use the enable
command to
access Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to
enter this mode from User
EXEC mode.
T1500-28PCT#
Enter the disable or the exit
command to return to User
EXEC mode.
Enter the configure com mand
to access
Global Configuration
mode.
Global
Configuration
Mode
Use the configure comm and
to enter this mode from
Privileged EXEC mode.
T1500-28PCT (config)#
Use the exit or the end
command or press Ctrl+Z to
return to
Privileged EXEC
mode.
Use the interface
fastEthernet/ gigabit Ethernet
port or interface range
fastEthernet/gigabitEthernet
port-list
command to access
interface Configuration mode.
Use the vlan vlan-list to access
VLAN Configuration mode.
Global C
onfiguration
Mode
Privileged EXEC
Mode
User EXEC Mode
Interface Configuration Mode
Interface gigabitEthernet
Interface link-aggregation
Interface range gigabitEthernet
Interface range link-aggregation
Interface vlan
……
VLAN Configuration Mode