CLI Reference Guide

11
Mode Accessing Path Prompt
Logout or Access the
next mode
Interface
Configuration
Mode
Use the interface
fastEthernet/gigabitEthernet
port or interface range
fastEthernet/
gigabitEthernet port-list
command t
o enter this mode
from
Global Configuration
mode.
T1500-28PCT
(config-if)#
or
T1500-28PCT
(config-if-range)#
Use the end
command or press
Ctrl+Z to return to Pri vileged
EXEC mode.
Enter the exit command or the
# command to return to Global
Configuration mode.
A port number must be
specified in the interface
command.
VLA N
Configuration
Mode
Use the vlan vlan-list
command to enter this mode
from
Global Configuration
mode.
T1500-28PCT
(config-vlan)#
Use the end
command or press
Ctrl+Z to return to Pri vileged
EXEC mode.
Enter the exit command
or the
# command to return to Global
configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a Telnet/SSH connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
 Global Configuration M ode : In this mode, global commands are provided, such as the
Spanning Tree, Schedule Mode and so on.
 Interface Configuration Mode: In this mode, users can configure one or several ports,
different ports corresponds to different commands
a). Interface fastEthernet/gigabitEthernet: Configure parameters for a Fast/Gigabit
Ethernet port, such as Duplex-mode, flow control status.
b). Interface range fastEthernet/gigabitEthernet: The commands contained are the
same as that of the Interface fastEthernet/gigabitEthernet. Configure parameters for
several Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface vlan: Configure parameters for the vlan-port.