CLI Reference Guide

86
Example
Configure the Duplex Mode as full-duplex for port 3:
T1500-28PCT(config)# interface fastEthernet 1/0/3
T1500-28PCT(config-if)# duplex full
speed
Description
The speed command is used to configure the Speed Mode for an Ethernet port.
To return to the default configuration, please use no speed command.
Syntax
speed { 10 | 100 | 1000 | auto }
no speed
Parameter
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are four
options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode (default).
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Configure the Speed Mode as 100Mbps for port 3:
T1500-28PCT(config)# interface fastEthernet 1/0/3
T1500-28PCT(config-if)# speed 100
storm-control broadcast
Description
The storm-control broadcast command is used to enable the broadcast
control function. To disable the broadcast control function, please use no
storm-control broadcast command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth, the packets will be automatically discarded
to avoid network broadcast storm.
Syntax
storm-control broadcast [rate rate]