User Guide

123
Choose the menu ACL→ACL Config→Exte nd-IP ACL to load the following page.
Figure 11-5 Create Extend-IP Rule
The following entries are displayed on this screen:

Create Extend-IP ACL
ACL ID: Select the desired Extend-IP ACL for configuration.
Rule ID: Enter the rule ID.
Operation:
Select the operation for the switch to process packets which match the
rules.
 Permit: Forward packets.
 Deny: Discard Packets.
S-IP: Enter the source IP address contained in the rule.
D-IP: Enter the destination IP address contained in the rule.
Mask:
Enter IP address mask. If it is set to 1, it must strictly match the
address.
IP Protocol: Select IP protocol contained in the rule.
S-Port:
Configure TCP/IP source port contained in the rule when TCP/UDP is
selected from the pull-down list of IP Protocol.
D-Port:
Configure TCP/IP destination port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
11.1.6 Combined ACL
Combined ACLs analyze and process data packets based on a series of match conditions,
including the source MAC addresses, destination MAC addresses, source IP addresses and
destination IP addresses carried in the packets.