Installation Manual

07
Smart PoE+ Switch
Installation
Lightening Protection
Extremely high voltage currents can be produced instantly when lightning occurs and the
air in the electric discharge path can be instantly heated up to 20,000
℃
. As this instant
current is strong enough to damage electronic devices, more effective lightning protection
measures should be taken.
■
Ensure the rack and device are well earthed.
■
Make sure the power socket has a good contact with the ground.
■
Keep a reasonable cabling system and avoid induced lightning.
■
Use the signal SPD (Surge Protective Device) when wiring outdoor.
Note: For detailed lightning protection measures, please refer to Chapter 3
Lightning Protection.
Installation Site
When installing the device on a rack or a flat workbench, please note the following
items:
■
The rack or workbench is flat and stable, and sturdy enough to support the
weight of 5.5kg at least.
■
The rack or workbench has a good ventilation system. The equipment room is
well ventilated.
■
The rack is well grounded. Keep the power socket less than 1.5 meters away from
the device.
2.3 Installation Tools
■
Phillips screwdriver
■
ESD-preventive wrist wrap
■
Cables
Note: These tools are not provided with our product. If needed, please self
purchase them.