User Guide

ManualsBrandstp-link ManualsTemperature Monitortp-link T315 Tapo Smart Temperature and Humidity Monitor

Table Of Contents

Appearance

Before You Start

A Tapo Hub is required. Make sure

your Tapo Hub is successfully added

via the Tapo app.

Remove the back panel and insert the

batteries. The Connection icon should

start to blink.

Note: If the Connection icon is not blinking, press and

hold the button for 5 seconds to reset your monitor.

1. Power Up Your Monitor

Quick Start Guide

Smart Temperature and

Humidity Monitor

7106509797 REV1.0.0

*Images may dier from actual products.

Humidity*

Display/Reset

Button

Temperature*

Vent Hole

Indicator Icons

• Single Press

Switch the temperature unit ℃/℉.

• Double Press

Switch the display position of temperature and

humidity.

• Press and hold for 5s

Reset your monitor to enter pairing mode.

Display/Reset Button

Battery Level

Connection

• Blinking: Connecting to hub

• Solid On: Connected to hub

• O: No connection

Battery level < 20%

Battery level < 5%

*You can press the button to

switch display position.

Inside Comfort Level

Outside Comfort Level

The default comfort level is temperatures between 20℃ (68℉)

- 26℃ (78.8℉) while humidity is between 30% - 60%.

You can customize the comfort level on the Tapo app.

Indicator Icons

Summary of content (3 pages)

PAGE 1
Indicator Icons Appearance 1 Vent Hole Quick Start Guide Smart Temperature and Humidity Monitor 2 Indicator Icons 3 Temperature* 4 Display/Reset Button 5 Humidity* *Images may differ from actual products. 7106509797 REV1.0.0 *You can press the button to switch display position.
PAGE 2
Set Up Your Monitor 2. Open the Tapo app and tap the button. Select Sensors and then your model. Follow the app instructions to complete setup. 3 3. Test Your Monitor Take the monitor to your preferred location. Make sure the Connection icon on the screen is solid on. If there is no connection icon, move it closer to your hub. 4. 4 Place Your Monitor (The installation height should not be higher than 2 meters.
PAGE 3
FCC compliance information statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.