User Guide

TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.1.1 ATM Interface
Choose “Advanced Setup”Æ“Layer2 InterfaceÆATM Interface”, you can Configure ATM
interfaces on the screen below.
Figure 4-2
¾ Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.
)
Note:
If the interface is used by the configuration of the 4.4.2
WAN Service, you need to remove the
corresponding WAN Service entry first before you can remove it here.
¾ Add: Click the button, and you can add a new interface in the next screen.
Figure 4-3
¾ VPI/VCI: the VPI and VCI values provided by your ISP. Do not change them unless it was
required by your ISP.
¾ DSL Link Type: Select a DSL Link Type which is provided by your ISP. The options include
EoA (it is for PPPoE, IPoE, and Bridge), PPPoA (PPP over ATM) and IPoA (IP over ATM).
¾ Encapsulation Mode: The mode of the data processing over the Link Type you have
selected. Uses the default setting, if you are not sure.
¾ Service Category: Select the type of the service assigned by your ISP in the drop-down list.
The default type is UBR Without PCR.
18