User Guide

TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
7. On the next screen you will see the detailed settings you’ve made. Please click the
Save/Apply button to save these settings.
Figure 4-11
8. On the next screen you will see the WAN Port Information Table with the new configuration.
Figure 4-12
¾ Remove All: Click Remove All, then all the interface in the table will be deleted.
¾ Remove: Select the check box in the table above and then click Remove, the corresponding
interface will be deleted in the table.
4.4.2.2 ATM-EoA-IPoE
If your ISP provides an IPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type (4.4.1.1
ATM Interface).
2. Click the Add button on the screen (as shown Figure 4-5). Select WAN Service Interface over
ATM PVC on the next screen (as shown Figure 4-6).
3. If your ISP provides an IPoE connection, select IPoE option for the WAN service type on the
screen (as shown Figure 4-7), and click Next button to continue.
4. Enter parameters in the following blanks to configure the WAN IP Address and click Next.
23