User Guide TF-3200 10/100M PCI Network Adapter Rev:1.0.
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2009 TP-LINK TECHNOLOGIES CO., LTD.
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
Package Contents The following contents should be found in your package: ¾ OneTF-3200 10/100M PCI Network Adapter ¾ One resource drivers CD for TF-3200 ¾ The other helpful information Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact with your distributor. Safety Notices Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm.
Chapter 1 Introduction 1.1 Overview of the product The TF-3200 10/100M PCI Network Adapter is a highly integrated and cost-effective Fast Ethernet Adapter that provides 32-bit performance, PCI bus controller, and full compliance with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX specifications and IEEE 802.3x Full Duplex Flow. The TF-3200 keeps low cost and eliminates usage barriers. It is the easiest way to upgrade a network from 10 to 100Mbps.
The green LED indicates if the 10 or 100Mbps STP/UTP has been link or not. When the LED radiate, it indicates the adapter connect to the network at 10/100Mbps speed. Otherwise, it indicates connection is not available. When the LED glitter, it means the STP/UTP port is receiving or transmitting data. Chapter 2 Installation Guide 2.1 Hardware Installation To install the adapter, follow these steps listed below: 1. Turn off your computer and unplug the power cord and all cables. 2.
Appendix A Specifications Normal Interface 32-bit PCI interface Standards IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX Software ODI driver for NetWare 4.x, 5.x, NDIS driver for Microsoft Windows 98SE, Windows 2000, Windows XP, Windows Vista, etc Transmission Rate 10Mbps, or 20Mbps.
