User Manual
Table Of Contents
- About This Guide
- Get to Know About Your Router
- Connect the Hardware
- Set Up Internet Connection Via Quick Setup Wizard
- Guest Network
- Parental Controls
- Bandwidth Control
- Network Security
- NAT Forwarding
- VPN
- Customize Your Network Settings
- Manage the Router
- FAQ
8
Chapter 2
Connect the Hardware
2. 2. 4. Access Point Mode
Create a wireless network from an Ethernet connection. This mode is suitable for
dorm rooms or homes where there’s already a wired router but you need a wireless
connection.
1. Switch the operation mode to
AP and connect the hardware according to Step A to D.
2. Connect your device to the router wirelessly. The SSID (wireless network name) and
password are on the router’s label.
B
C
D
A
Wired Router
Internet
2. 2. 5. Repeater/Bridge Mode
Repeat signal from an existing wireless network. This mode is suitable to extend
wireless coverage, reaching devices that were previously too far from your host router
to maintain stable wireless connection.
1. Switch the operation mode to
AP and connect the hardware according to Step A and
B.
2. Connect your device to the router wirelessly or via an Ethernet cable. The SSID
(wireless network name) and password are on the router’s label.
Host Router
Internet
A
B