User manual

TL-MR6400
300Mbps Wireless N 4G LTE Router
 DTIM Interval - This value determines the interval of the Delivery Traffic Indication
Message (DTIM). You can specify the value between 1-255 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
 Enable WMM - WMM function can guarantee the packets with high- priority messages
being transmitted preferentially. It is strongly recommended enabled.
 Enable Short GI - This function is recommended for it will increase the data capacity
by reducing the guard interval time.
 Enable AP Isolation - Isolate all connected wireless stations so that wireless stations
cannot access each other through WLAN. This function will be disabled if WDS/Bridge
is enabled.

Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep
the provided default values; otherwise it may result in lower wireless network performance.
4.8.5 Wireless Statistics
Choose menu “Wireless
→
Wireless Statistics”, and then you can see the MAC Address,
Current Status, Received Packets and Sent Packets for each connected wireless station.
Figure 4-26 The router attached wireless stations
 MAC Address - The connected wireless station's MAC address.
 Current Status - The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP /
AP-DOWN / Disconnected.
 Received Packets - Packets received by the station.
 Sent Packets - Packets sent by the station.
 Configure - The button is used for loading the item to the Wireless MAC Filtering list.
Deny: if the Wireless MAC Filtering function enable, deny the station to access.
Allow: if the Wireless MAC Filtering function enable, allow the station to access.
-40-