User Guide

-57-
The following items are displayed on this screen:
 General
Disable Bandwidth
Control:
Select this option to disable Bandwidth Control.
Enable Bandwidth
Control all the time:
Select this option to enable Bandwidth Control all the time.
Enable Bandwidth
Control When:
With this option selected, the Bandwidth Control will take effect when the
bandwidth usage reaches the specified value.
 Default Limit
Limited Bandwidth:
Default Limit applies only for users that are not constrained by Bandwidth
Control Rules. These users share certain bandwidth with upper limit
configured here. Value 0 means all the remained bandwidth is available to
use.
 Interface Bandwidth
Interface:
Displays the current enabled WAN port(s). The Total bandwidth is equal to
the sum of bandwidth of the enabled WAN ports.
Upstream
Bandwidth:
Displays the bandwidth of each WAN port for transmitting data. The
Upstream Bandwidth of WAN port can be configured on WAN page.
Downstream
Bandwidth:
Displays the bandwidth of each WAN port for receiving data. The
Downstream Bandwidth of WAN port can be configured on WAN page.
Note:
● The Upstream/Downstream Bandwidth of WAN port you set must not be more than the bandwidth
provided by ISP. Otherwise the Traffic Control will be invalid.
● If there are data flowing into the router from interface A and out from interface B while the
downstream bandwidth of A is different from the upstream bandwidth of B, then the smaller one
should be considered as the effective bandwidth, and vise versa.
● Click the <View IP Traffic Statistics> button to jump to IP Traffic Statistics page.