Installation Manual

3. Select the connection type to connect to the ISP. Then click Next. 4. If Auto-Detect is chosen, the router will detect the Internet connection

type provided by your ISP automatically.

Appendix: Troubleshooting

With the router powered on, use a pin to press and hold the RESET button

(for about 5 seconds) until the SYS LED lights up and ashes quickly. Then

release the button and wait while the router reboots, restoring it to its factory

default settings.

You can restore the router to factory defaults. The default management

address of the router is http://192.168.0.1. The default username and

password are both admin. All current settings will be cleared once the router

is restored. If you have a backup of your congurations, you can import it

after the factory restore is complete.

What should I do if I forget the user name and password for the

router's web management page?

What could I do if I forgot the username and

password of the Router?

5. You can also specify the connection type as PPPoE, Dynamic IP or

Static IP. Click Next and follow the instruction to continue. For other

connection types, go to Network > WAN. A PPPoE example is shown

below.

6. Click Finish to complete the quick installation.

How do I restore the router to its factory default settings?

Management > Factory Defaults, and click Restore to Factory Defaults. The

router will restore and reboot automatically.

Why is the web management page not displaying properly?

Please try the following:

1) Update your web browser or try a dierent web browser.

2) If pop-ups are being blocked, please lower the security level of your web

browser.

What should I do if I can't access the web management page?

If the computer is set to a static or xed IP address, change its settings to

obtain an IP address automatically.

Enter http://192.168.0.1 in the web browser and press Enter.

Use another web browser and try again.

Reboot your router and try again.

Disable then enable the network adapter being used.

Why is the PWR LED working abnormally?

The PWR LED should be lit when the power system is working normally. If

it is not, please check the following:

1) Make sure that the power cable is connected properly, and the power

contact is normal.

2) Make sure the voltage of the power supply meets the requirements for

the input voltage of the router.

For technical support and other information, please visit

http://www.tp-link.com/support, or simply scan the QR code.

この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあります。この場合には使

用者が適切な対策を講ずるよう要求されることがあります。 VCCI-A