Operation Manual

The following entries are displayed on this screen:

¾ Bandwidth Control Setting

Port:

Select the desired port for bandwidth control configuration. It is

multi-optional.

Status:

Allows you to enable or disable the bandwidth control function..

Rate(Kbit/sec):

Select the rate for receiving/sending packets on the port. The

packet traffic exceeding the rate will be discarded. It ranges from

0 to 100000, and must be integral multiple of 64.

Type: Select to control the ingress/egress traffic rate on each port. It is

multi-optional.

• Ingress: If the rate for receiving packets on the port exceeds

the set rate, the packets will be discarded.

• Egress: If the rate for sending packets on the port exceeds

the set rate, the packets will be discarded.

Note:

1. If you enable ingress bandwidth control feature for the storm control-enabled port, storm

control feature will be disabled for this port.

2. When egress bandwidth control feature is enabled for one or more ports, you are suggested

to disable the flow control on each port to ensure the switch works normally.

6.3 Storm Control

Storm control function allows the switch to filter broadcast, multicast and UL frame in the network.

If the transmission rate of the chosen packets exceeds the set bandwidth, the packets will be

automatically discarded to avoid network broadcast storm.

On this page you can configure and view the storm control function information.

Choose the menu QoS→Storm Control to load the following page.