Installation Manual

7106508144 REV4.1.0

5/8/16-Port Gigabit Desktop Switch

Note: For simplicity, we will take TL-SG108 for example throughout this Guide.

On: Power on

O: Power o

LED Explanation

Power

Link/Act (For TL-SG105/TL-SG105S/TL-SG108/TL-SG108S)

Connection

Installation Guide

TL-SG105/TL-SG105S/TL-SG108/TL-SG108S/TL-SG116

Ethernet Ports (1-8)

Router

LAN PortWAN Port

Internet

TL-SG108

Power Adapter

Link/Act

Link/Act (Green)

On:

Running at 10/100/1000Mbps

O:

Flashing: Transmitting/receiving data

No device is linked to the

corresponding port

1000M (Green)

On: Running at 1000Mbps

Flashing: Transmitting/receiving data

10/100M (Yellow)

On: Running at 10/100Mbps

Flashing: Transmitting/receiving data

Link/Act (For TL-SG116)

PAGE 1
Link/Act (For TL-SG105/TL-SG105S/TL-SG108/TL-SG108S) Installation Guide Link/Act (Green) On: Running at 10/100/1000Mbps 5/8/16-Port Gigabit Desktop Switch Off: No device is linked to the corresponding port TL-SG105/TL-SG105S/TL-SG108/TL-SG108S/TL-SG116 Flashing: Transmitting/receiving data Link/Act (For TL-SG116) 1000M (Green) On: Running at 1000Mbps Flashing: Transmitting/receiving data 10/100M (Yellow) On: Running at 10/100Mbps Flashing: Transmitting/receiving data Note: For simplicity, we will ta
PAGE 2
Frequently Asked Questions (FAQ) Q1. The Power LED is not lit. The Power LED should be lit when the power system is working normally. If the Power LED is not lit, check as follows: A1: Make sure the power adapter is connected to the switch with power source properly. A2: Make sure the voltage of the power supply meets the requirements of the input voltage of the switch. A3: Make sure the power source is ON. Q2. The Link/Act LED is not lit when a device is connected to the corresponding port.