Specifications

119
Syntax
storm-control unicast [ rate rate ]
no storm-control unicast
Parameter
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# storm-control unicast
bandwidth
Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
Syntax
bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]}
no bandwidth { all | ingress | egress }
Parameter
ingress-rate —— Specify the bandwidth for receiving packets. Range:1-102400
for the megaport, 1-1024000 for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:1-102400
for the megaport, 1-1024000 for the gigaport.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for port
5: