CLI Reference Guide

power inline consumption(interface)
Description
The power inline consumption command is used to configure the power limit
the corresponding port can supply.
Syntax
power inline consumption { power-limit | auto | class1 | class2 | class3 |
class4 }
Parameter
power-limit —— The max power the port in the profile can supply, with five
options: “power-limit”, “auto”, ”class1”, “class2”, “class3” and “class4”.
“Power-limit” indicates you can manually enter a value ranging from 1 to 300.
The value is in the unit of 0.1 watt. For instance, if you want to configure the max
power as 5w, you should enter 50. “Auto” indicates the value is assigned
automatically by the PoE switch. “Class1” represents 4w. “Class2” represents
7w. “Class3” represents 15.4w. “Class4” represents 30w.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the power limit as “5w” for port 2:
TL-SG3424P(config)# interface gigabitEthernet 1/0/2
TL-SG3424P(config-if)# power inline consumption 50
power inline priority
Description
The power inline prior ity command is used to configure the PoE priority for the
corresponding port
Syntax
power inline priority { low | middle | high }
168