CLI Reference Guide

5. Configure the port selected in the step above as the following Figure 1-4 shown.
Configure Bits per se cond as 38400, Data bits as 8, Par ity as None, Stop bits as 1,
Flow control as None, and then click OK.
Figure 1-4 Port Settings
6. The DOS prompt” TL-SG3424>” will appear after pressing the Enter button as Figure 1-5
shown. It indicates that you can use the CLI now.
Figure 1-5 Log in the Switch
1.1.2 Configuring the Privileged EXEC Mode Password
To configure the switch remotely by a Telnet or SSH connection, please set a password for entering
the Privileged EXEC Mode through the console connection first. Follow the steps in
1.1.1 Logon
by a console port to log on to the switch, and then follow the steps shown in Figure 1-6 to
configure the Privileged EXEC Mode password.
6