CLI Reference Guide

Mode Accessing Path Prompt
Logout or Access the next mode
Global
Configuration
Mode
Use the configure
command to enter this
m ode from
Privileged
EXEC mode.
TL-SG3424 (config)#
Use the exit or the e nd
command or
press Ctrl+Z to return to Pri vileged
EXEC mode.
Use the interface gigabitEthernet port
or interface rang
e gigabit Ethernet
port-list
command to access interface
Configuration mode.
Use the vlan vlan-list
to access VLAN
Configuration mode.
Interface
Configuration
Mode
Use the interface
gigabitEt hernet port
or interface range
gigabitEt hernet
port-list command to
enter this mode from
Global Configuration
mode.
TL-SG3424
(config-if)# or
TL-SG3424
(config-if-range)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit or the #
command to
return to Global Configuration mode.
A port number must be specified in the
interface command.
VLA N
Configuration
Mode
Use the vlan vlan-list
command to enter this
m ode from Global
Configuration mode.
TL-SG3424
(config-vlan)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit or the #
command to
return to Global configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and
the switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.
 Global Configuration Mode: In this mode, global commands are provided, such as
the Spanning Tree, Schedule Mode and so on.
 Interface Configuration Mode: In this mode, users can configure one or several
ports, different ports corresponds to different commands
a). Interface gigabitEthernet: Configure parameters for an Ethernet port, such as
Duplex-mode, flow control status.
b). Interface range gigabitEthernet: The commands contained are the same as that
of the Interface gigabiteEthernet. Configure parameters for several Ethernet
ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface vlan: Configure parameters for the vlan-port.
17