Operation Manual

Note:
When using the SFP port with a 100M module or a gigabit module, you need to log on to the GUI
(Graphical User Interface) of the Switch and configure its corresponding Speed and Duplex mode
on Switching→Port→Port Config page. For 100M module, please select 100MFD while select
1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD.
2.3.2 Rear Panel
The rear panel of TL-SL2218/TL-SL2428 features a power socket and a Grounding Terminal
(marked with ). The rear panel of TL-SL2218 is shown as the following figure.
Figure 2-3 Rear Panel of TL-SL2218
The rear panel of TL-SL2428 is shown as the following figure.
Figure 2-4 Rear Panel of TL-SL2428
¾ Grounding Terminal: TL-SL2218 and TL-SL2428 already come with Lightning Protection
Mechanism. You can also ground the Switch through the PE (Protecting Earth) cable of AC
cord or with Ground Cable. For detail information, please refer to Installation Guide.
¾ AC Power Socket: Connect the female connector of the power cord here, and the male
connector to the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage (100-240V~ 50/60Hz 0.3A for TL-SL2218 and 100-240V~
50/60Hz 0.6A for TL-SL2428 ).
Return to CONTENTS
7