Quick Installation Guide

ManualsBrandsTP-Link ManualsComputer AccessoriesTL-WN951N V3

Hardware Connection

300Mbps Wireless N PCI Adapter

MODEL NO. TL-WN951N

7106504347 REV1.1.0

For Windows Vista

For Windows XP

You may see the Found New Hardware Wizard after the

adapter has been inserted. Please click ‘Cancel’.

Package Contents

System Requirement

· Windows 8 Windows7 · Windows Vista · Windows XP

Resource CD

QIG

300Mbps Wireless Lite N PCI Adapter

MODEL NO. TL-WN951N

Steps:

1. Turn o your computer and unplug the power cord from the computer.

2. Open the case. Locate an available PCI slot and remove its slot cover.

Keep the screw.

3. Insert the adapter into the PCI slot as shown above.

4. Secure the adapter with the screw removed in Step 2.

5. Close the case and insert the power cord back into the computer.

6. Turn on your computer.

Insert the TP-LINK Resource CD into the CD-ROM

drive.

Find the appropriate model and choose

Install Driver&Utility.

Select Install TP-LINK Wireless Conguration

Utility and Driver and then click Next .

Click Change to specify the destination location

or you can leave it default. Click Next to continue.

Click Install to install the driver and utility for your

adapter.

TL-WN951N

Software Installation

(The installation procedures in Windows 8/ 7/ Vista/ XP are similar. Here takes the procedures in Windows 7 for example.)

The following screen will then appear.

Click Finish to complete the setup.

The installation of the driver and utility may take

1~2 minutes.

The InstallShield Wizard window will appear.

Click Next to continue.

TL-WN951N

300Mbps PCI

300Mbps Wireless N PCI Adapter

Summary of content (2 pages)

PAGE 1
Package Contents 1 Hardware Connection You may see the Found New Hardware Wizard after the adapter has been inserted. Please click ‘Cancel’. For Windows XP 300Mbps Wireless Lite N PCI Adapter 30 0M 30 0M bp TL s -W N9 Wirel 51 es N s bp N sP PC I Ad ap CI ter Quick Installation Guide MODEL NO. 300Mbps Wireless N PCI Adapter TL-WN951N TL-WN951N QIG For Windows Vista Steps Resource CD 1. Turn off your computer and unplug the power cord from the computer. 2. Open the case.
PAGE 2
3 Connect to Network 1 (You can skip to Appendix: Connect to Wireless Router by WPS to quickly connect to a network if your Router or Access Point features WPS or QSS function.) After installation, the configuration page will pop up on your desktop. 2 Click Network in the tools section to display a list of available wireless networks. Highlight the target network name (e.g. TP-LINK_Network1) and then click Connect to build a connection. 3 If the network is unsecured, you will directly connect to it.