Quick Installation Guide

Ethernet Cable

Extender

TL-WPA7510

Adapter

TL-PA7010

Powerline

Router

Internet

1000Mbps

* TL-WPA7510 KIT (European version) is used for demonstration in this guide.

Attention

Wall Outlet

2. Plug powerline devices into wall outlets instead of power strips.

Using power strip will aect network performance or even cause connection drops.

1. Use the product only in the upright direction.

Quick Installation Guide

Plug and Play

TL-WPA7510 KIT

Power Strip

1000Mbps

SSID:TP-LINK_XXXX

SSID:TP-LINK_XXXX_5G

Wireless Password:XXXXXXXX

SSID:TP-Link_XXXX

SSID:TP-Link_XXXX_5G

Wireless Password:XXXXXXXX

Tip:

Want to unify Wi-Fi networks or personalize your network?

See the back page for instructions.

Plug the adapter into a power outlet

and connect it to the router’s LAN

port via an Ethernet cable.

Plug the extender into a power outlet on the same electrical circuit.

Wait until the extender’s Powerline LED turns on.

Note: If the LED is blinking or o, please refer to FAQ > Q2.

Connect your devices to the internet using the default SSID (network

name) and password on the label at the top of the extender.

1000Mbps

SSID:TP-LINK_XXXX

SSID:TP-LINK_XXXX_5G

Wireless Password:XXXXXXXX

WAN LAN

PAGE 1
Quick Installation Guide 2 Plug the extender into a power outlet on the same electrical circuit. TL-WPA7510 KIT Wait until the extender’s Powerline LED Note: If the LED is blinking or off, please refer to FAQ > Q2. S S S ID S W ID :T ir :T P-L e P le IN s -L K s IN P K _X a _ X s X s w X XX o X rd X :X _ X 5G X X X X X X On 3 * TL-WPA7510 KIT (European version) is used for demonstration in this guide. Plug and Play turns on.
PAGE 2
Unify Your Wi-Fi Networks via WPS Personalize Your Network Manage your powerline devices using any of the methods below. You can change the SSID and password, set Wi-Fi schedules, create a guest network and more. Copy SSID and password from your router via WPS to create one unified Wi-Fi network throughout your home. Note: If your router doesn’t have a WPS button, manually change the extender’s Wi-Fi settings via the tpPLC app, tpPLC Utility, or web interface.