Quick Installation Guide

Ethernet Cable

Extender

TL-WPA8631P

Adapter

TL-PA8010P

Powerline

Router

Internet

LAN

WAN

Plug the adapter into a power outlet

and connect it to the router’s LAN

port via an Ethernet cable.

Connect your devices to the internet using the default SSIDs (network names)

and password on the label at the side of the extender.

Tips:

Want to unify Wi-Fi networks or personalize your networks?

See the back page for instructions.

Quick Installation Guide

TL-WPA8631P KIT

* TL-WPA8631P KIT (European version) is used for demonstration in this QIG.

* Images may dier from actual products.

Plug in the extender

into a power outlet on the same electrical circuit

Wait until the extender’s

Powerline LED turns on.

Note:

1. If only one wall outlet is available, plug both devices into a power strip for setup, then

relocate to wall outlets before enjoying the internet.

2. If the extender’s Powerline LED is o, try another wall socket, or refer to Create a Secure

Powerline Network by Pairing on the back page to pair the powerline devices.

Attention

2. Plug powerline devices into wall outlets instead of power strips.

Using power strip will aect network performance or even cause connection drops.

1. Use the product only in the upright direction.

Wall Outlet Power Strip

SSID:TP-Link_XXXX

SSID:TP-Link_XXXX_5G

Wireless Password:XXXXXXXX

PAGE 1
Quick Installation Guide 2 TL-WPA8631P KIT * TL-WPA8631P KIT (European version) is used for demonstration in this QIG. * Images may differ from actual products. On 3 Plug in the extender into a power outlet on the same electrical circuit. Wait until the extender’s Powerline LED turns on. Note: 1. If only one wall outlet is available, plug both devices into a power strip for setup, then relocate to wall outlets before enjoying the internet. 2.
PAGE 2
Unify Your Wi-Fi Networks Personalize Your Networks Copy SSID and password from your router via any of the methods below to create one unified Wi-Fi network throughout your home. Note: If your router doesn’t support the two methods below, refer to Personalize Your Networks section to manually change the extender’s Wi-Fi settings. Method ONE: Via Wi-Fi Button Method TWO: Via OneMeshTM 1 Press your router’s WPS button. 2 (Within 2 minutes) press the extender’s Wi-Fi button for 1 second.