User manual
Determine Operation Mode
Congure the Router
Standard Wireless Router
Standard Wireless Router
Access Point
Repeater
Client
To share a wired (Ethernet) connection to wireless devices, when in a
hotel room, small office, etc.
To transform an existing wired (Ethernet) network to a wireless one.
To extend the range of an existing Wi-Fi network.
To function as a wireless adapter to connect your wired device (e.g.
Blu-ray® players, smart TVs, or game consoles) to a Wi-Fi network.
Operation Modes Application
Access Point
1 Switch the Operation Mode to Router/AP and connect the hardware
according to step A to C in the left diagram.
2 Connect your device to the router wirelessly or via an Ethernet cable.
The Wi-Fi network name and password are on the router’s label.
3 Launch a web browser and type http://tplinkwifi.net in the address
bar. Enter admin (in lowercase) for both username and password to
log in.
4 Click Next to start the Quick Setup. Select Standard Wireless Router
mode and click Next.
5 Select the WAN Connection Type and follow the instructions. When
using the router in a hotel room or a small office, select Dynamic IP.
Note: If the router is successfully connected to the Internet, this step
will be skipped.
6 On the Wireless page, either customize your Wireless Network Name
and Wireless Password or keep the default ones , and then click Next.
7 Click Finish to complete the configuration.
1 Switch the Operation Mode to Router/AP and connect the hardware
according to step A to C in the left diagram.
2 Connect your device to the router wirelessly or via an Ethernet cable.
The Wi-Fi network name and password are on the router’s label.
3 Launch a web browser and type http://tplinkwifi.net in the address
bar. Enter admin (in lowercase) for both username and password to
log in.
4 Click Next to start the Quick Setup. Select Access Point mode and click
Next.
5 Either customize your Wireless Network Name and Wireless
Password or keep the default ones, and then click Next.
6 Select the LAN IP type of the router or leave the default setting Smart
IP for most cases, and then click Next.
7 Click Reboot to complete the configuration.
7106506246 REV2.0.0
*TL-WR810N (European version) is used
for demonstration in this QIG.
Quick
Installation Guide
300Mbps Wi-Fi Pocket Router/AP/
TV Adapter/Repeater
LAN/WAN
Internet
B
C
A
LAN
OR
300Mbps TL-WR810N
Internet
Wired Router
C
LAN/WAN
B
A
300Mbps TL-WR810N
300Mbps TL-WR810N
Mode Switch
Install the plug and determine the operation mode of the router as you need.